Cradlepoint DSPMOD-CP Installationshandbuch Seite 1

DSPMOD-CP-S/CDMA & DSPMOD-CP/CDMA External CDMA Modem Kit

-10- Removing the IBR650 from the Mounting BracketFrom the top of the bracket, press down fi rmly on the router using your thumb(s) and pull the device

-11-2. Plug the power supply into an electrical outlet and connect it to the IBR650.3. Make sure the power is switched on.O = OFF I = ONRX Diversity P

-12-Enter the default password, which is csi1234. Modem ActivationCradlePoint IBR650E Setup Instructions for Verizon Wireless DSP DeploymentsStep 1 -

-13-Step 2: Activating the CradlePoint IBR650E on the Verizon Wireless Network:Click on the Internet tab, then select Connection ManagerNext, highli

-14-Click on the Activate buttonThe modem will now contact the Verizon Wireless Network for authentication. If the ESN has been set up with an active

-15-Step 3: Con• guring your modem for port forwarding, to support one or multiple devices:CradlePoint IBR650E modems purchased from CSI will be pre

-16- LAN SettingsUnder Network Settings, select Local Networks. On both Primary & Guest LAN, DHCP Server should be dis-abled to prevent misuse of

-17- Additional FeaturesSystem Automatic Reboot – The CradlePoint IBR650E allows you to set an automatic reboot daily, weekly or monthly. Go to Syste

-18- Step 4: Connecting the modem to the repeaterYour modem comes with a kit that includes everything you need to connect it in line with the donor an

-19-DonorCS05-102-429 10dB Directional Coupler375-1014-001 Modem375-1013-001 SwitchRepeatersTypical Connection Plan For the DSPMOD-CP-S/CDMA Coa

-2-This page intentionally left blank.

-20-DonorRepeaterTypical Connection Plan For the DSPMOD-CP/CDMA Coax N Male to N MaleINOUT-10dBRX/TX PortRX DiversityPort(See Note)Note: Donor m

-21- Functionality TestYou must be connected to the internet for the following steps. Once you’ve made your physical connections, connect your laptop

-22-Scroll down and highlight “Internet Protocol (TCP/IP) and click on the “Properties” button.Right click on Local Area Connection - and select “Prop

-23-Select “Use the following IP address:” and enter “192.168.1.2.” The subnet mask should automatically popu-late to “255.255.255.0.While most devic

-24-IndexAActivating the CradlePoint IBR650E on the Verizon Wireless Network 13Additional Features 17Additional LED Indications 7Additional Tips 2

-25- WarrantyThis is a one year limited warranty. Seller warrants that its prod-ucts are transferred rightfully and with good title; that its prod-uct

-26-Notes

Notes-27-

960-1147-003 rev A ECO 2707

-3-Table of ContentsProduct Registration Information ... 4DISCLAIME

ApplicationThis guide should be applied whenever a need exists to activate and/or add a wireless modem capability to Digital Repeater in an existing

Product Introduction This document describes the CradlePoint IBR650E Setup Instructions for Verizon Wireless DSP Deployments. Prior to Installation V

-6-CradlePoint IBR650E Hardware Overview Ports, LED’s and Switches Reset: You can return your router to factory default settings by pressing and hol

-7- Modem Antennas: The IBR650 comes with two modem antennas to enhance reception for the embedded modem. These antennas are simple to attach and adju

-8- Mounting Bracket

-9- Attaching the IBR650 to the Mounting Bracket1) Attach the bracket to the wall or other surface with screws. NOTE: Screws are not provided because