
Known issues:
IPSec. Certificates do not work if Router Services used (new feature in 5.2.0)
Release Notes for CradlePoint Rev 5.1.2 Firmware:
New features added in this release (2100, MBR1400, IBR6x0,
MBR1200B, CBA750B only. Not all features are in all products – see
their respective Data Sheets):
Config difference CLI command: ‘diff’ from the command line will show any configuration
items that are different than the default.
ARP CLI command: ‘arpdump’ from the command line will dump the ARP table.
(IBR6x0) Prepend System ID to GPS Sentences. System Settings -> Administration -> GPS
-> Include System ID.
(IBR6x0) Increase the maximum number of GRE tunnels from 5 to 10.
Network Mobility (NEMO) changes to support failover. NEMO can be configured to operate
with a specific WAN and will activate when a disconnection is detected from a primary WAN
connection, or BGP or VRRP detect a peer failure.
Additional UI/Usability changes:
Added a Red/Green indicator to the banner showing if the router is connected to ECM.
For CradlePoint-based modems with supporting GPS, added ability to select between AUX
and GPS ports to obtain coordinates.
Defects fixed:
NHRP with dual WAN connections does not come back up after a WAN failover
SSH ‘cat’ command occasionally skips config portions
Special Characters in System Identifier field can cause UDHCP to fail
IBR600P/IBR650P only. Enabled SMS access for these devices
Added data throttling to resolve a USB overrun situation that resulted in the router rebooting
itself
Kommentare zu diesen Handbüchern